Low Inertia, Power Grip spares

Low Inertia (LI) Clutches are well suited for high cycle applications, such as steel shears and stamping presses. The Low Inertia design reduces the rotational mass during starts and stops, allowing for increased cycles per minute and reduced deceleration times. This advantage also leads to reduced heat generation during dynamic braking conditions. Low Inertia Clutches are available in 1, 2, or 3 plate construction with diameters ranging from 6 through 60 inches.

Low Inertia (LI) Brakes are well suited for high cycle and tension control applications, such as steel shears and unwind stands. The LI brakes utilize a ventilated design to optimize the airflow in and out of the brake. This increased airflow allows the brake to run cool in high cycle applications. Low Inertia Brakes are available in 1, 2, or 3 plate construction with diameters ranging from from 6 through 60 inches

The Power Grip Clutch is designed to accommodate shaft-to-shaft power transmission applications with large inertia loads. Our air-tube design allows seamless, controlled engagement and disengagement with minimal air volume. Power Grip clutches allow for quick response, space-saving footprints, minimal maintenance requirements and are available in sizes ranging from 8” to 60”.